GLX M14 Cruiser Scooter Motorcycle Half Helmet with Free Tinted Retractable Visor DOT Approved (Black, Medium)

DESIGN CONCEPT
Gives you more coverage while still keeping weight to a minimum.
DOT testing was performed by SGS. The conducted is based on FMVSS 49 CFR 571.218
3-POSITION SHIELD MECHANISM
Levers can be quickly and easily adjusted to one of three preset positions.
Quickly and easily remove and/or replace the shield. (No tools required)
INTERCOM-READY DESIGN
Designed for Seamless Integration with Bluetooth Communication Systems.
Additional built-in compartments designed to encompass audio enhancement equipment or similar communication systems.
PREMIUM FINISHES
Unmatched attention to detail and premium aesthetics.
Synthetic leather around the bottom edge of the interior for ease of cleaning and added styling.
CLEAR & SMOKE SHIELDS
All shields are tested to ensure compliance with the DOT standards.
The Anti-Scratch clear shield protects the rider against wind, dirt, and insects.
The FREE tined shield protects from 99% of the sun's damaging UV rays.
COMMON PROBLEMS
Helmet sizing information
To achieve proper helmet fitment, begin by finding your head circumference size using the method described below. Remember that the helmet size you choose should fit around the crown of your head comfortably with no pressure points. The cheek pads should fit firmly around your face. Once your chin strap is fastened, grab the helmet's chin bar and move it side to side. Your cheeks should move with the helmet, which should not slide across your face. Different thickness cheek pads can be purchased to obtain the perfect fit.
Head measurement instructions
Wrap a flexible tape measure around your head approximately one inch above the eyebrows and ears. Use this measurement (in either inches or centimeters) to find your helmet size in the chart above.
My ears get folded over when I put my helmet on
That’s normal. Watch a MotoGP race, and you’ll even see the pros adjusting their ears as they gear up. As long as you can push your ears back to a natural position and your ears do not hurt, you’re good to go. Again, it’s all about how the helmet fits once it’s actually in position.
I can’t even get my head into the helmet, even though the chart said this was my size
That might actually be your size. GLX helmets have more neckroll cushioning than others. Hold the helmet by the two straps, with your thumbs pressing the straps against the helmet. Gently spread the helmet’s opening a little, then try pulling it over your head. If it still doesn’t fit, don’t force it. Stop and try the next size up.
I think my helmet is too tight
If you can’t put it on at all, then that’s obviously too tight. If you can get it on, but it hurts where it presses against your head, that’s also too tight. If it’s snug all around, too snug to chew gum, that’s about right. Don’t forget about that 15 percent to 20 percent break-in that will occur.
GLX M14 Cruiser Motorcycle Half Helmet